A stylus pressure gauge is a tool that is used to measure the amount of force that a turntable’s stylus applies to a record. This is important because the correct amount of stylus pressure will help to prevent the stylus from damaging the record.
Here are the steps on how to use a Pro-ject stylus pressure gauge:
- Find the stylus pressure gauge. The stylus pressure gauge is usually located on the back of the turntable, near the tonearm. It is a small, weight with a scale on it.
- Set the stylus pressure gauge to the correct weight. The weight of the stylus pressure gauge will depend on the type of cartridge that you are using. You can find the correct weight in the manual for your cartridge.
- Place the stylus pressure gauge on the record. Place the stylus pressure gauge on the record so that the stylus is resting on the scale.
- Adjust the tracking force. Adjust the tracking force of the turntable until the stylus pressure gauge reads the correct weight.
- Test the stylus pressure. Play a record and listen for any skipping or distortion. If you hear any skipping or distortion, you may need to adjust the tracking force again.
Here are some additional tips:
- Be sure to use the correct weight for your cartridge. Using too much or too little stylus pressure can damage your records.
- If you are not sure how to adjust the tracking force, you can consult the manual for your turntable.
- If you are having trouble adjusting the tracking force, you can ask for help from a friend or a professional.
By following these steps, you can use a Pro-ject stylus pressure gauge to ensure that your turntable is applying the correct amount of stylus pressure.
Additional information:
- The stylus pressure gauge is usually calibrated in grams.
- The amount of stylus pressure you need will be listed in the manual for your cartridge.
- If you are using a cartridge with a high tracking force, you will need to use a higher amount of stylus pressure.
- If you are using a cartridge with a low tracking force, you will need to use a lower amount of stylus pressure.
I hope this helps!
