A Floyd Rose is a type of floating bridge that allows for a wide range of vibrato effects. However, this can also make it difficult to keep the guitar in tune, especially when using the dive bomb technique.
If you want to be able to use the dive bomb technique without affecting the tuning of your guitar, you can block the Floyd Rose so that it can only move up, but not down. This is called “blocking a Floyd Rose dive only.”
There are a few different ways to block a Floyd Rose dive only. One way is to use a piece of wood or plastic. You can cut a piece of wood or plastic to the size of the bridge, and then glue it in place so that it blocks the bridge from moving down.
Another way to block a Floyd Rose dive only is to use a tremolo lock. A tremolo lock is a small device that fits between the bridge and the body of the guitar. It prevents the bridge from moving down, which can help to keep the guitar in tune.
If you do not want to use a piece of wood or plastic or a tremolo lock, you can also block a Floyd Rose dive only by adjusting the tension of the springs. The springs are located in the back cavity of the guitar. If you tighten the springs, it will make it more difficult for the bridge to move down, which will help to keep the guitar in tune.
However, tightening the springs too much can make it difficult to use the tremolo arm. So, it is important to find a balance between keeping the guitar in tune and being able to use the tremolo arm.
Here are the steps on how to block a Floyd Rose dive only using a piece of wood or plastic:
- Remove the strings from the guitar.
- Cut a piece of wood or plastic to the size of the bridge.
- Glue the piece of wood or plastic in place between the bridge and the body of the guitar so that it blocks the bridge from moving down.
- Replace the strings on the guitar.
Here are the steps on how to block a Floyd Rose dive only using a tremolo lock:
- Remove the strings from the guitar.
- Locate the tremolo lock. It is usually located on the back of the guitar, near the bridge.
- Insert the tremolo lock between the bridge and the body of the guitar so that it blocks the bridge from moving down.
- Tighten the screws on the tremolo lock.
- Replace the strings on the guitar.
Here are the steps on how to block a Floyd Rose dive only by adjusting the tension of the springs:
- Remove the strings from the guitar.
- Locate the springs in the back cavity of the guitar.
- Use a screwdriver to tighten the screws on the springs until the bridge is no longer able to move down.
- Replace the strings on the guitar.
Here are some tips for blocking a Floyd Rose dive only:
- Make sure that the piece of wood or plastic is properly aligned. If it is not, it may not be able to block the bridge properly.
- Use a small amount of glue when attaching a piece of wood or plastic to the bridge. Too much glue can make it difficult to remove the wood or plastic later on.
- Be careful not to overtighten the screws on the springs. If you do, it may be difficult to use the tremolo arm.
With a little care, you can easily block a Floyd Rose dive only and keep your guitar in tune.
