A bridge adjustment screw is a small screw located on the tonearm of a turntable. It is used to adjust the height of the tonearm so that the stylus is in the correct position to play the record.
The bridge adjustment screw is typically located near the base of the tonearm. It is a small, Phillips head screw that can be adjusted by hand.
To adjust the bridge adjustment screw, you will need to:
- Turn off the turntable and unplug it from the power outlet.
- Remove the record from the turntable.
- Locate the bridge adjustment screw.
- Use a Phillips head screwdriver to turn the screw clockwise to raise the tonearm or counterclockwise to lower the tonearm.
- Once the tonearm is in the correct position, tighten the screw with the screwdriver.
- Replace the record on the turntable and turn on the turntable.
The bridge adjustment screw is an important part of setting up a turntable. By adjusting the bridge adjustment screw, you can ensure that the stylus is in the correct position to play the record and prevent damage to the stylus or the record.
Here are some additional tips for adjusting the bridge adjustment screw on a turntable:
- Be careful not to over-tighten the screw. Over-tightening the screw can damage the tonearm.
- If you are not sure how to adjust the bridge adjustment screw, consult the owner’s manual for your turntable.
- Once you have adjusted the bridge adjustment screw, play a test record to make sure the stylus is in the correct position. If the stylus is not in the correct position, you may need to adjust the bridge adjustment screw again.
By following these tips, you can safely and effectively adjust the bridge adjustment screw on your turntable.
