Yes, Audio Technica turntables need speakers in order to produce sound. Turntables do not have built-in speakers, so they need to be connected to an external audio system. This can be either a passive or active system.
Passive audio systems require an amplifier in order to power the speakers. The amplifier takes the low-level signal from the turntable and boosts it to a level that can drive the speakers.
Active audio systems have built-in amplifiers, so they do not require a separate amplifier. Active systems are typically more expensive than passive systems, but they are also easier to set up.
How to connect an Audio Technica turntable to speakers:
To connect an Audio Technica turntable to speakers, you will need a pair of RCA cables. These cables have red and white connectors on each end. The red connector goes to the right channel input on the speakers, and the white connector goes to the left channel input.
Once you have connected the RCA cables, you will need to set the preamp switch on the back of the turntable to “Line” or “Phono”. If you are using an active audio system, you will need to set the preamp switch to “Line”. If you are using a passive audio system, you will need to set the preamp switch to “Phono”.
Once the turntable is connected to the speakers, you can start playing records!
Here are some additional tips for connecting an Audio Technica turntable to speakers:
- Make sure that the RCA cables are properly connected to the turntable and the speakers.
- Make sure that the preamp switch on the back of the turntable is set to the correct position.
- If you are using a passive audio system, make sure that the amplifier is turned on.
- Adjust the volume control on the amplifier or speakers to the desired level.
If you have any trouble connecting your Audio Technica turntable to speakers, please consult the owner’s manual or contact Audio Technica customer support for assistance.
