How do you oil an old turntable?

Old turntables can benefit from being oiled from time to time to keep the moving parts lubricated and prevent them from wearing out. Here are the steps on how to oil an old turntable:

1. Disconnect the turntable from the power source. This is an important safety precaution to take before you start working on the turntable.
2. Remove the platter. The platter is the flat disc that the record sits on. To remove it, you will usually need to loosen a screw or two.
3. Locate the spindle bearing. The spindle bearing is the part that supports the spindle and allows it to rotate smoothly. It is usually located in the center of the platter.
4. Apply a small amount of lubricant to the spindle bearing. You can use a light oil or silicone lubricant. Be sure to wipe away any excess lubricant.
5. Replace the platter. Be sure to tighten the screws securely.
6. Reconnect the turntable to the power source.

Here are some additional tips for oiling an old turntable:

• Use a lubricant that is specifically designed for turntables. Do not use WD-40 or other general-purpose lubricants, as these can damage the delicate parts of the turntable.
• Apply the lubricant sparingly. Too much lubricant can be just as bad as not enough.
• Wipe away any excess lubricant. Excess lubricant can attract dust and dirt, which can damage the turntable.
• Be careful not to get any lubricant on the stylus. The stylus is the part of the cartridge that makes contact with the record. Any lubricant on the stylus can damage the record.

By following these tips, you can help to keep your old turntable running smoothly and prevent damage to the delicate parts.

Here are some of the lubricants that you can use on an old turntable:

• SAE 30 oil: This is a common type of oil that is used in many different applications. It is a good lubricant for turntables because it is not too thick and it will not attract dust.
• Silicone lubricant: This is a clear lubricant that is made from silicone. It is a good lubricant for turntables because it is non-conductive and it will not damage the delicate parts of the turntable.
• Record cleaner: Some record cleaners also contain lubricants that are safe to use on turntables.

If you are not sure what lubricant to use on your turntable, it is always best to consult with a qualified technician. They will be able to recommend the best lubricant for your turntable and help you to apply it correctly.